EasyFix - Nr.II is a general purpose construction panel adhesive specifically designed to work with TPC & TPU filaments.
EasyFix adhesives are designed to adhere firmly to a heated build plate, keeping an object firmly attached to the build plate. On the other hand, it also has excellent release properties when the build plate is cold. This makes it easier to remove a printed object from the build plate, while reducing the risk of damaging the build plate and the printed object in the process.
How to use EasyFix 3D printing adhesives:
There is an EasyFix adhesive solution for 3D printing with almost all types of 3D printer filament. Shake the bottle well with EasyFix before use. Make sure your 3D printer's build plate is clean and at room temperature before applying EasyFix to your 3D printer's print bed. Press the applicator sponge onto the build plate so that the EasyFix 3D printing adhesive saturates the applicator sponge. Let the EasyFix glue gradually saturate the applicator sponge. Never squeeze the bottle!
When the applicator sponge is saturated, you can apply the EasyFix adhesive evenly to the printable surface of your 3D printer's build plate. Make sure your 3D printer's z-height is correct before you start 3D printing. EasyFix glue sticks firmly when your building board is heated.
Wait for your 3D printer's build platform to cool to room temperature before removing your 3D printed object. EasyFix 3D printing adhesives have excellent release properties, which means that your 3D printed object releases from the build platform of the 3D printer when it cools. If the 3D printed object is still difficult to remove, you can apply a small amount of warm water to the printed object and the printing surface. Let the water pass under the 3D printed object before slowly removing it.
A build platform prepared with EasyFix glue can be used for multiple 3D prints.
Storing your EasyFix adhesives:
EasyFix 3D printing adhesives should be stored upright in a cool, dry place out of direct sunlight. It is important to store the EasyFix construction panel adhesive in an upright position, so that the applicator sponge cannot become saturated with EasyFix during storage. Make sure the screw cap of your EasyFix adhesive is tightly closed. This prevents the applicator sponge from drying out. The applicator sponge can be rinsed off with EasyFix in tap water once dry.
To clean the build plate of your 3D printer:
Rinse the build plate with warm water to remove any excess glue. Alternatively, you can use a cloth or sponge soaked in lukewarm water for this.
Discover EasyFix 3D printing adhesives: