Contents CO2 laser machine maintenance package
The CO2 laser machine maintenance package is for the maintenance of the mechanical parts of your CO2 laser machine. Consisting of:
- Bio Cleaner to remove excess and contaminated grease.
- Multi Cleaner to keep the machine clean internally.
- Lubricate grease including the grease gun to provide the parts with new grease.
- Foam tips (10 pieces) & cleanroom tissues (10 pieces) for cleaning mirrors and lenses.
Besides the starter set, the products are also available separately and help you to keep your machine in optimum conditions.
EP2 Lithium lubricant / grease
In order for the machine to function properly, the moving parts of new grease are regularly essential. Only then will the machine always deliver the best results, as expected.
After cleaning with the Bio Clean, apply new grease to the slide bearings and ballscrews with the supplied grease pump. Remove the caps on both sides. Install and apply the grease cartridge in the grease pump. Spread well with a finger or brush. Remove excess fat.
CAUTION: Never allow the electronic parts, mirrors or lenses to come into contact with grease. This causes damage to the relevant parts that negatively affect the proper functioning of the machine!
During the use of the laser cutting machine, vapors, dust and cutting residue are generated that descend into the machine and are therefore also absorbed in the lubricants / greases. In order to maintain a properly functioning machine, the contaminated fats must be removed regularly.
Preferably, you clean the machine once a month with normal use. Use a cloth or paper towel to remove the excess and existing grease from the guides. This means that most of the contaminated fat has already been removed.
Now use the BIO CLEAN to inject the guides and any ballscrew with a moderate dose of liquid through the nozzle. After spraying, rub it clean with a cloth that does not fluff and make sure the parts are free of grease and contaminants. The parts are then ready to be provided with new grease.
ATTENTION: Do not use the BIO CLEAN on MIRRORS AND LENSES !! Avoid touching the liquid with the lenses and mirrors. Apply as carefully as possible to the parts to be cleaned, not to be used on electronic components.
In order to continue to use the machine as good and pleasant as possible, regular cleaning is important. Nothing works as well as a well-functioning, well-kept machine. And that includes the outside. Clean the smooth surfaces regularly with the MULTI CLEAN FOAM.
Apply as desired, when the machine gets dirty on the inside / outside, this is easy to clean with the Multiclean. Only use the aerosol on smooth surfaces and clean the machine with a clean dry cloth.
You can also use Multi Clean Foam for cleaning mirrors and lenses.
The grease pump is used to apply the lubricant / grease to the guides